Hoshizaki KMD-410MAH Instruction Manual page 12

7) Pass the bin control connector through the hole from the bottom to the top of the unit.
8) While pulling up the bin control lead, hook the bin control on the right side interior wall.
Then push the bin control up against the bottom of the unit, and slide to the back until
it snaps in place. Make sure the slotted holes at the right side of the bin control are
securely placed on the collars at the bottom of the unit. See Fig. 5.
Make sure the bin control is securely in place. Otherwise, ice may get
between gaps and damage the bin control.
9) Connect the bin control connector to the side of the control box.
10) Replace the water tank, cube guide, pump motor bracket, pump motor and float switch
in their correct positions until they snap in place.
11) Secure the pump motor bracket with the two thumbscrews.
12) Reconnect the pump motor connector and float switch connector.
13) Replace the front insulation and front panel in their correct positions.
CAUTION
Bin Control
Fig. 5
9
Collars