Final Checklist - Hoshizaki KMD-410MAH Instruction Manual

H. Final Checklist
1) Is the icemaker level?
2) Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°
C to +38°C) and the water temperature within +45°F to +90°F (+7°C to +32°C) all year
around?
3) Is there at least 6" (15 cm) clearance at rear, left side, and top and 12" (30 cm)
clearance at right side for proper air circulation and maintenance or service?
4) Have all shipping cartons, tape, and packing material been removed from the
icemaker? Is the cube guide in its correct position?
5) Are all components, fasteners and thumbscrews securely in place?
6) Have all electrical and piping connections been made?
7) Has the power supply voltage been checked or tested against the nameplate rating?
Has a proper ground been installed to the icemaker?
8) Are the water supply line shut-off valve and drain valve installed? Has the water supply
pressure been checked to ensure a minimum of 10 PSIG and a maximum of 113
PSIG?
Note: The icemaker may stop running when the water supply is off, or if the pressure
is below 10 PSIG. When the proper water pressure is reached, the icemaker
automatically starts running again.
9) Are the compressor hold-down bolts snug? Have the refrigerant lines been checked to
make sure they do not rub or touch other lines or surfaces?
10) Has the bin control switch been checked for correct operation? To confirm bin control
operation, press the bin control's actuator paddle during the first 5 minutes of the freeze
cycle. The compressor and fan motor should de-energize within 15 seconds, then the
drain valve should energize until the water tank empties. After the water tank empties,
the pump motor and drain valve should de-energize.
11) Has the end user been given the instruction manual, and instructed on how to operate
the icemaker and the importance of the recommended periodic maintenance?
12) Has the end user been given the name and telephone number of an authorized service
agent?
13) Has the warranty card been filled out and forwarded to the factory for warranty
registration?
13