Table of Contents
Advertisement
3.1
Main body section
3.1.1 Remove the top cover (See figure 1)
(1) Remove the four screws A attaching the top cover on both
sides of the main body.
(2) Remove the five screws B attaching the top cover on the
back of the main body.
(3) Raise the both sides and lower part of the rear of the top
cover, with opening them slightly in an outward direction.
And the top cover will be removed.
3.1.2 Remove the front panel assembly (See figure2, figure 3)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the mechanism assembly.
(1) Disconnect the card wires from connectors CN7002,
CN7003,
CN4001
on the main board and display board.
(2) Hooks a and b are removed respectively, and the front
panel assembly is removed.
1-8 (No.YD058)
SECTION 3
DISASSEMBLY
A
2
x
CN4001
Front panel assembly
Hook a
TOP COVER
TOP COVER
TOP COVER
B
A
2
x
B
Fig.1
Front panel assembly
CN7002
CN7003
Display board
Main board
Fig.2
Hook a
Fig.3
B
B
B
Advertisement
Table of Contents
