Table of Contents
Advertisement
NOTES OF SCHEMATIC DIAGRAM
Safety precautions
The Components indentified by the symbol
critical for safety. For continued safety, replace safety
critical components only with manufacturer's recom-
mended parts.
1. Units of components on the schematic diagram
Unless otherwise specified.
1) All resistance values are in ohm. 1/6 W, 1/8 W (refer to
parts list).
Chip resistors are 1/16 W.
K: KΩ(1000Ω), M: MΩ (1000KΩ)
2) All capacitance values are in µF, (P: PF).
3) All inductance values are in µH, (m: mH).
4) All diodes are 1SS133, MA165 or 1N4148M (refer to parts
list).
Note: The Parts Number, value and rated voltage etc. in
the Schematic Diagram are for references only.
When replacing the parts, refer to the Parts List.
2. Indications of control voltage
AUX : Active at high.
AUX or AUX(L) : Active at low.
3. Interpreting Connector indications
1
Removable connector
2
3
1
Wire soldered directly on board
2
3
1
Non-removable Board connector
2
3
1
2
Board to Board
3
4
Connected pattern on board
The arrows indicate signal path
Note: For the destination of each signal and further line
connections that are cut off from the diagram,
refer to "BOARD INTERCONNECTIONS"
2-1
CHARTS AND DIAGRAMS
4. Voltage measurement
1) Regulator (DC/DC CONV) circuits
!
are
2) Indication on schematic diagram
REC mode
Note: If the voltages are not indicated on the schematic
6. Indication of the parts for adjustments
The parts for the adjustments are surrounded with the circle
as shown below.
7. Indication of the parts not mounted on the circuit board
"OPEN" is indicated by the parts not mounted on the circuit
board.
REC : Colour bar signal.
PB : Alignment tape (Colour bar).
—
: Unmeasurable or unnecessary to measure.
Voltage indications for REC and PB mode on the sche-
matic diagram are as shown below.
1
2
2.5
1.8
(5.0)
PB and REC modes
(Voltage of PB and REC modes
PB mode
are the same)
diagram, refer to the voltage charts.
R216
OPEN
3
Advertisement
Table of Contents
