Table of Contents
Advertisement
3.2.2 Remove the traverse mechanism assembly (See figure 3, figure 4, figure 5)
• Prior to performing the following procedure, remove the
clamper base and tray.
(1) It solder to part b section on the pick-up unit.
Pick-up unit
(2) Disconnect the card wire from connector
up unit.
ATTENTION:
Please extract the wire after short-circuited on the pick-
up unit in part b with solder. Please remove the solder of
part b after connecting the wire with
bling.
(3) Disconnect the flexible wire from connector
servo control board.
(4) Remove the one screw B attaching the mechanism brack-
et.
(5) Remove the four screws C and D attaching the leaf spring.
(6) Remove the two screws E and F attaching the traverse
mechanism assembly.
(7) When a traverse mechanism assembly is in the lowest po-
sition, a gear 1 is turned clockwise, and since a traverse
mechanism assembly is moved to the upper position, it is
removed.
1-12 (No.YD058)
Part b
CN1
on the pick-
CN1
when reassem-
CN301
on the
D
E
F
Mechanism
bracket
Fig.3
Servo control board
Fig.4
Traverse mechanism assembly
Gear 1
Fig.5
Leaf spring
CN1
Pick-up unit
B
Traverse mechanism
assembly
CN301
Advertisement
Table of Contents
