Table of Contents
Advertisement
3.2.3 Remove the flexible wire assembly (See figure 6)
• Prior to performing the following procedure, remove the
clamper base and tray.
(1) Remove the four screws G and H attaching the flexible wire
assembly.
(2) Remove the solder part c soldered to the feed motor.
(3) Remove the two screws I attaching the shaft guide.
(4) Disconnect the flexible wire from connector
spindle motor board.
3.2.4 Remove the servo control board and board bracket (See figure 7, figure 8)
• Prior to performing the following procedure, remove the
clamper base and tray.
(1) Remove the soler part d and e soldered on the servo con-
trol board.
(2) Disconnect the flexible wire from connector
servo control board.
(3) Disconnect the card wire from connector
servo control board.
(4) Remove the two screws J attaching the servo control
board.
(5) Remove the four screws K attaching the board bracket.
Servo control board
J
CN101
Part d
3.2.5 Remove the loading motor (See figure 7, figure 8)
• Prior to performing the following procedure, remove the
clamper base and tray.
(1) Remove the soler part d soldered on the servo control
board.
(2) A belt is removed.
(3) Remove the two screws L attaching the loading motor.
CN1
on the
CN301
CN101
on the
Part e
J
CN301
Fig.7
Part c
G
Flexible wire
assembly
K
on the
K
Spindle motor assembly
I
CN1
H
G
Fig.6
L
Belt
K
Fig.8
G
(No.YD058)1-13
Advertisement
Table of Contents
