Table of Contents
Advertisement
5.6
Taking out a disc
5.6.1 Method 1
There is compulsive tray ejection mode by electric operation.
(1) AC Plug is pulled out at once and inserted again.
(2) It is displayed on FL display as "LOADING", and while it blinks, pushing the EJECT button of a main body is continued.
(3) After a while, a tray opens (About 20 seconds).
(4) A disk is removed, the tray is pushed, and a tray is made to close.
(5) The "LOADING" blink display of FL display disappears and it will be in a standby state.
(6) If the POWER button is pushed, it will usually be operating.
5.6.2 Method 2
When a disk is not able to be taken out by operation of "Method 1"
A tray can be ejected mechanically, without switching on a power supply.
(1) A drive unit is removed from a main body.
(2) The part a on the reverse side of a drive unit is made to slide in the direction of an arrow with a screw driver etc.
(3) Since a tray ejects a few, a tray is pulled out manually.
5.7
Initialization to the factory shipment state
When the initialization is operated, internal information changes as follows. It is essential to obtain the client's permission before the
operation.
• All DVD library is all deleted.
• All the DVD initial settings go back to the initial status.
(1) Set to the JIG mode.
(2) Transmit "43-6F" with the JIG remote control unit.
(3) FL indicator displays "FACTORY", and changes to "CHECK OK" after blinking for a short while.
(4) Pull out the power code from the wall socket.
(5) The JIG mode is forced to cancel at the same time with the initialization, check whether the JIG mode is canceled by plugging
the power code into the wall socket again. (The colon ":" in time display should be continuously ON, not blinking.)
If the JIG mode is not canceled, transmit "43-9D" with JIG remote control unit to cancel the JIG mode.
Part a
(No.YD058)1-19
Advertisement
Table of Contents
