Advertisement
3.1
Main body section
3.1.1 Remove the top cover (See figure 1)
(1) Remove the four screws A attaching the top cover on both
sides of the main body.
(2) Remove the five screws B attaching the top cover on the
back of the main body.
(3) Raise the both sides and lower part of the rear of the top
cover, with opening them slightly in an outward direction.
And the top cover will be removed.
3.1.2 Remove the front panel assembly and HDD (See figure 2, figure 3, figure 4)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the drive unit.
(1) Remove the five screws C attaching the HDD and bracket.
(2) Disconnect the card wire from connector
digital board.
(3) Disconnect the socket wire from connector
main board.
(4) Disconnect the card wire from connector on the HDD.
(5) Disconnect the card wire from connector
main board.
(6) Disconnect the card wires from connector CN7002,
CN7003
on the display board.
(7) Remove the two screws D attaching the front panel assem-
bly.
(8) Hooks a and b are removed respectively, and the front
panel assembly is removed.
CN2201
HDD
C
C
C
Connector
C
SECTION 3
DISASSEMBLY
CN2201
CN5304
CN4001
Bracket
Main board
C
CN5304
Fig.2
A
2
x
CN4001
on the
on the
on the
Front panel assembly
D
Hook a
TOP COVER
TOP COVER
TOP COVER
B
A
x
2
B
Fig.1
CN7003
CN7002
Main board
Fig.3
Hook a
D
Fig.4
B
B
B
(No.YD089B)1-5
Advertisement
