Honeywell MX9 User Manual page 270

Parameter
Auth Timeout
Certs Path
Ping Payload
Ping Timeout ms
Ping Delay ms
11 - 18
Default
8 seconds Specifies the number of seconds the Summit software waits for an EAP
authentication request to succeed or fail.
If the authentication credentials are stored in the active profile and the
authentication times out, the association fails. No error message or
prompting for corrected credentials is displayed.
If the authentication credentials are not stored in the active profile and the
authentication times out, the user is again prompted to enter the
credentials.
Options are: An integer from 3 to 60.
System A valid directory path, of up to 64 characters, where WPA Certificate
Authority and User Certificates are stored on the mobile device when not
using the Windows certifcates store. The Windows folder must exist before
assigning the path in this parameter. See
Certs Path (page 11-21) for instructions on obtaining CA and User
Certificates.
Options are: none.
For example, when the valid certificate is stored as My Computer/System/
MYCERTIFICATE.CER, enter System in the Certs Path text box as the
Windows folder path.
32 Bytes Maximum amount of data to be transmitted on a ping.
Options are: 32 bytes, 64, 128, 256, 512, or 1024 bytes.
5000 The amount of time, in milliseconds, that a device will be continuously
pinged. The Stop Ping button can be tapped to end the ping process ahead
of the ping timeout.
Options are: Any number between 0 and 30000 ms.
1000 The amount of time, in milliseconds, between each ping after a Start Ping
button tap.
Options are: Any number between 0 and 30000 ms.
Function
Windows Certificate Store vs.