Data - Honeywell MX9 User Manual

Contact
On Startup – Connect to the Mobile Device Server when the Enabler is accessed.
On Resume – Connect to the Mobile Device Server when resuming from Suspend mode.
On IP Change - Connect to the Mobile Device Server when the IP address of the MX9 changes.
On Ext. Power – Initiate connection to the Mobile Device Server when the device is connected to an external power
source, such as based on a docking event.
Periodic Update
Allows the administrator to configure the Enabler to contact the Mobile Device Server and query for updates at a regu-
lar interval beginning at a specific time.
Wakeup device if suspended
If the time interval for periodic contact with the Mobile Device Server occurs, a mobile device that is in Suspend Mode
can wakeup and process updates.
Reboot before attempt
Reboot mobile device before attempting to contact Mobile Device Server.
Require external power
Only connect when the mobile device has external power.
Use relative offset
Dimmed.

Data

The Data tab controls when data is transferred between the MX9 and the Mobile Device Server.
Transfer Data When Device is Idle
When enabled, periodic updates from the Mobile Device Server are postponed until the MX9 has been idle for the
specified period of time. The default is disabled.
Idle timeout
Specify the length of time the device must be idle before a periodic update can run, used when the parameter above is
enabled.
Real-time Statistics
When checked, the statistics are transmitted over the network by the Enabler.
Report
Specifies the Report Interval, how frequently the Enabler reports statistics to the Mobile Device Server.
Retransmit After Server Contact
Specifies if the device sends statistics to the Mobile Device Server immediately following a connection to the server.
10 - 9