D10 Rio Cable; D10 Rio Bus Adapter - IBM eserver pSeries 7311 D10 Service Manual

D10 RIO Cable

Removal
1. Turn off the power to the system.
2. Release the RIO cable retainers.
3. Disconnect the RIO cable.
Replacement
Replace in reverse order.

D10 RIO Bus Adapter

Removal
Before performing the following procedure, read the "Safety Considerations" on
page 53.
1. Turn off the system power.
2. Perform the procedure to put the I/O subsystem into the service position as
described in "D10 Service Position" on page 57.
3. Remove the service access cover. (See "D10 Covers" on page 59).
4. Remove the screws that attach the RIO riser card to the I/O subsystem chassis.
5. Carefully pull the card straight up and out of the slot.
Replacement
Replace in reverse order.
Chapter 8. Removal and Replacement Procedures
121