D10 RIO Cable
Removal
1. Turn off the power to the system.
2. Release the RIO cable retainers.
3. Disconnect the RIO cable.
Replacement
Replace in reverse order.
D10 RIO Bus Adapter Assembly
Removal
Before performing the following procedure, read the "Safety Considerations" on page 41.
1. Turn off the system power.
2. Perform the procedure to put the I/O subsystem into the service position as described in "D10 Service
Position" on page 43.
3. Remove the service access cover. (See "D10 Covers" on page 44).
4. Remove the screws that attach the RIO riser card to the I/O subsystem chassis.
5. Carefully pull the card straight up and out of the slot.
Replacement
Replace in reverse order.
109
Chapter 3. Removal and Replacement Procedures