Brinkmann Natural Gas Conversion Kit Installation Manual page 8

Step 7
Figure 1 shows valve stem and bezel
with the control knob removed. Take
seven large stop plates from the
component card and place them over
the main, side and sear burner valve
stems as illustrated (Figure 2). Verify
the tab and the stamped letter on the
stop plates face out. Replace control
knobs when finished.
WARNING: We recommend and
request that you do not remove the
control panel in order to access the
LP gas orifices. If you choose to
remove the control panel, you must
replace the control panel bezels
exactly as illustrated in Figure 2.
Failure to replace the bezels as
illustrated could lead to personal
injury and/or property damage.
Step 8
Carefully replace each main burner,
making sure burner openings slide
over valve nozzles. Attach each
burner using screws and nuts that
were set aside in Step 4. Replace
two screws in side burner bracket
that were set aside in Step 2.
Step 9
Replace warming rack, cooking
grills, heat distribution plates and
grease tray.
7
Tab
Figure 1
Stop Plate
Stop Pin
Figure 2
Cooking Grills
Heat
Distribution
plates
Warming Rack