Brinkmann Natural Gas Conversion Kit Installation Manual page 16

Step 7
Figure 1 shows valve stem and bezel
with the control knob removed. Take
six large stop plates from the
component card and place them over
the valve stems as illustrated
(Figure 2). Verify the tab and the
stamped letter on the stop plates face
out. Replace control knobs when
finished.
WARNING: We recommend and
request that you do not remove the
control panel in order to access the
valve tips. If you choose to remove
the control panel, you must replace
the control panel bezels exactly as
illustrated in Figure 2. Failure to
replace the bezels as illustrated could
lead to personal injury and/or
property damage.
Step 8
Carefully replace each burner,
making sure burner openings slide
over valve nozzles. Screw each main
burner "foot" down using screwdriver
and screws that were set aside in
Step 4. Replace cotter pin in side
burner "foot" that was set aside in
Step 2.
Step 9
Replace warming rack, cooking grills,
heat shields and grease tray.
Note: Follow directions in the leak
testing section of this manual
before using this grill.
15
Tab
Figure 1
Stop Plate
Stop Pin
Figure 2
Warming Rack
Cooking Grills
Heat Shields