Brinkmann Natural Gas Conversion Kit Installation Manual page 13

Cover Bolts
Retaining Nut
Existing Rotisserie LP
Replacement Rotisserie
(identified by number)
Rotisserie Burner 1.35 mm (RED)
Cover Bolts
Brass Orifice
Gas Orifice
Natural Gas Orifice
Inside View
Outside View
810-8533-F ROTISSERIE BURNER
CAUTION: Only use specified
natural gas orifice for your grill.
Note: It is helpful to keep the
screws with the components
as they are removed for ease
of reassembly.
Step 10
Remove the three bolts from inside
grill back panel to gain access to
the rotisserie LP gas orifice on back
side of grill. Set aside for later use.
Step 11
Using an adjustable wrench to hold
the gas line secure, use the open
end wrench provided to loosen the
gas line retaining nut. With the
rotisserie gas supply line detached
from the housing, use two wrenches
to remove the LP brass orifice from
the gas supply line. Replace the LP
gas brass orifice with the proper
natural gas orifice.
(1.35 mm RED)
Note: Bending the hose could
damage the supply line.
Step 12
Reattach gas supply line to the
rotisserie housing by securing with
the retaining nut removed in Step
11.
Note: Leave the back panel off
until the
conversion and all gas leak
testing has been
completed.
Step 13
Re-install rotisserie cover using the
bolts that were set aside in Step 10.
Note: Follow directions in the leak
testing section of this manual
before using this grill.
end of
12