Brinkmann Natural Gas Conversion Kit Installation Manual page 12

Step 7
Figure 1 shows valve stem and bezel
with the control knob removed. Take
five large stop plates from the
component card and place them over
the main and side burner valve stems
as illustrated (Figure 2). Take the
small stop plate from the component
card and place it over the rotisserie
burner valve stem (Figure 3). Verify
the tab and the stamped letter on the
stop plates face out. Replace control
knobs when finished.
WARNING: We recommend and
request that you do not remove the
control panel in order to access the
LP gas orifices. If you choose to
remove the control panel, you must
replace the control panel bezels
exactly as illustrated in Figure 2.
Failure to replace the bezels as
illustrated could lead to personal
injury and/or property damage.
Step 8
Carefully replace each burner,
making sure burner openings slide
over LP gas orifices. Screw each
main burner "foot" down using
screwdriver and screws that were
set aside in Step 4. Replace cotter
pin in side burner "foot" that were
set aside in Step 2.
Step 9
Replace warming rack, cooking
grills, heat shields and grease tray.
11
Tab
Figure 1
Tab
Figure 3
Stop Plate
Stop Pin
Figure 2
Stop Plate
Stop Pin
Cooking Grills
Heat Shields
Warming Rack