Optional Stainless Steel Inner Panel Install - Regency IP28-NG Owners & Installation Manual

OPTIONAL STAINLESS STEEL INNER PANEL INSTALL

Stainless panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for
damage after installation will not receive consideration.
To protect the fi nish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (even
when removing protective coating).
Stainless panels will discolor a little during normal operation. This is normal and should not be considered a defect.
All hand and fi nger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave a
fi lm/residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat to
the unit. Failure to do this will result in burn stains on panels which you will be unable to remove. This is not a warranty item.
1) Remove the primary guard and faceplate. Unplug polarized plug
for the switches.. Refer to instructions in this manual.
2) Remove glass and glass retainers.
Refer to instructions in this manual for detailed instructions.
3) Remove all the logs if installed and set aside carefully.
4) Remove the two side brackets and screws (set aside) - then
remove the side panels by tilting the top in and lifting them out.
Orient the stainless side panels with the angled corner facing the
5)
back of the fi rebox.
Angled corner
in panel
Regency IP28 Gas Inbuilt Fireplace
Before you start:
6) Secure the stainless panel with original bracket and screw - repeat
procedure on the opposite side.
Reinstall the logs, glass door, inner door frame with screen
7)
and fi nally the faceplate. See manual for detailed instructions.
Final installation of optional stainless panels.
INSTALLATION
19