Xerox Phaser 3635MFP Service Manual page 73

• Tray 2 assembly, PL 8.15 Item 28.
b. Perform OF7 Main PWB Check RAP.
Draft 4
Phaser 3635MFP
07-231 Check the Tray Feed Area RAP
07-231 The machine has detected that paper is jammed in the tray 2 paper feeding area at
power on.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: The front cover assembly interlock switch must be closed to supply +24V to the motors
and clutches.
Refer to Wiring Diagram 11. Perform the following:
1. Pull out tray 2. Remove all jammed paper.
2. Remove the pickup roll assembly, PL 8.17 Item 31. Check that the pickup roll is clean. If
necessary, install a new pickup roll assembly, PL 8.17 Item 31.
3. Enter dC330 code 08-920 to run the tray 2 feed motor.
4. Check the wiring between the tray 2 feed motor and CN8 on the Tray 2 PWB.
5. While the tray 2 feed motor runs, stack the code 08-820 to energize the tray 2 pickup
clutch (CL08-820). Check that the tray 2 pickup roll assembly, PL 8.17 Item 31 and feed
roll, PL 8.17 Item 12 rotate. Install new components as necessary, PL 8.17.
6. Check the wiring between the tray 2 pickup clutch and CN11 on the Tray 2 PWB.
7. If necessary, install new components:
• Tray 2 feed motor, PL 8.15 Item 23.
• Tray 2 PWB, PL 8.17 Item 25.
• Tray 2 assembly, PL 8.15 Item 28.
2-23
WARNING
Status Indicator RAPs
07-230, 07-231