Lsu Error Rap - Xerox Phaser 3635MFP Service Manual

06-100, 06-200 LSU Error RAP

06-100 The machine has detected that the LSU did not reach a ready state within the correct
time.
06-200 The machine did not detect the laser beam within the correct time.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Avoid exposure to laser beam. Invisible laser radiation.
Refer to Wiring Diagram 5. Perform the following:
1. Switch off the machine, then switch on the machine.
2. Enter dC330 codes 06-100 and 06-110. Check that the LSU motor is up to normal speed.
NOTE: Code 06-110 will display low when the LSU motor runs at normal speed.
3. Check the wiring between the LSU and CN24 on the Main PWB.
4. Remove the print cartridge, PL 9.10 Item 1. Check that the LSU interlock switch actuator
on the print cartridge is not damaged.
5. Check the LSU interlock switch, PL 6.10 Item 2.
6. Check the wiring between the LSU interlock switch and CN21 on the Main PWB. If neces-
sary, install a new LSU interlock switch, PL 6.10 Item 2.
7. If necessary:
• Install a new LSU, PL 6.10 Item 1.
• Perform OF7 Main PWB Check RAP.
Draft 4
Phaser 3635MFP 2-19
Status Indicator RAPs
06-100, 06-200