Scp 5 Subsystem Maintenance - Xerox Phaser 3635MFP Service Manual

Machine Settings
To make any adjustments to the machine, refer to ADJ 1.1 Machine Settings.
Additional Information
If necessary, refer to the following general procedures and information:
• GP 1 Diagnostics Entry
• GP 2 Fault Codes and History Files
• GP 3 Machine Status
• GP 4 System Administration Tools
• GP 5 Reports
• GP 6 Firmware Upgrade
• GP 7 Machine Specifications
• GP 8 DADF Document Feeding Specifications
• GP 9 Paper and Media Specifications
• GP 10 General Disassembly Precautions
• GP 11 Service Information
• GP 12 User Interface Tests Description
• GP 13 Installation Space Requirements
• GP 14 Glossary of Terms, Acronyms and Abbreviations
• GP 15 Shading Test
• GP 16 High Frequency Service Items
• GP 17 Restriction of Hazardous Substances (RoHS)
• GP 18 Scan Edge Print
Draft 4
Phaser 3635MFP

SCP 5 Subsystem Maintenance

Subsystem Maintenance contains information regarding the component life of the machine.
Procedure
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Go to the relevant procedure:
• Component Life
• HFSI
Component Life
The design life of the major components are shown in Table 1. Environmental conditions and
actual use will vary these factors. The component life shown in Table 1 is for reference only.
Table 1 Component life expectancies
Part Component life
DADF retard pad assembly 50k feeds
DADF pickup assembly 80k feeds
Tray 1 pickup roll 150k feeds
Tray 2 pickup roll 150k feeds
Transfer roll 100k prints
Fuser assembly 100k prints
Starter print cartridge 5K prints
Print cartridge 10K prints
1-5
WARNING
Parts list reference
PL 5.30 Item 2
PL 5.25 Item 2
PL 10.22 Item 14
PL 8.17 Item 31
PL 9.10 Item 2
PL 10.10 Item 1
PL 9.10 Item 1
Service Call Procedures
SCP 4, SCP 5