Brick Replacement; Baffl E Removal - Quadra-Fire 4100I-GD-B Manual

The fi rebox is lined with high quality fi rebrick which has excep-
tional insulating properties. There is no need for a grate,
simply build a fi re on the fi rebox of your insert.
. Be certain coals are completely cold. Remove all old
1
brick and ash from unit and vacuum out fi rebox.
2. Remove new brick set from box and lay out to THE
diagram as shown.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide
top of bricks under clip on back of fi rebox wall and push
bottom of brick back.
5. Install side bricks. Slide top of brick under clips on side
of fi rebox and push the bottom of the brick until it is fl ush
with the side of the unit.
Item Brick Size
1 9 x 4-1/2 x 1-1/4" with hole
2 9 x 4 x 1-1/4" with cut
3 4-1/2 x 3 x 1-1/4"
4 9 x 4-1/2 x 1-1/4"
5 9 x 3 x 1-1/4"
6 9 x 1-1/2 x 1-1/4"
NOTE: The baffl e material is 2700° Fiber Board. Removing hardware exposed to combustion processes can be frustrating. If
your reason for removing the baffl e is simply to clean the chimney, you have alternatives which will save time and effort. Call
a qualifi ed chimney sweep or an authorized Quadra-Fire dealer for details.
1. Remove all ash from fi rebox, and extinguish all hot embers before disposal into a metal container.
2. Remove ceramic blanket from above the baffl e.
3. With a 3/16" Allen wrench, remove 2 front manifold tube retainer bolts on the air channel under the end of the front tubes. NOTE:
Soak the bolts with penetrating oil for at least 15 minutes before trying to remove them. Figure 21A.
4. To remove manifold tubes, slide the tube to one side until one end is out of its hole. Then, while lifting that end of the fi ber board
baffl e, pull tube up over the air channel and out of hole at the other end. It is necessary to remove the fi rst two tubes in order to
remove the baffl e. NOTE: When replacing the manifold tubes, be sure the tube with the larger holes is placed in the front for
your insert to operate properly.
5. Slide fi ber board baffl e forward to front of stove and straight out through door. Figure 21B.
6. To install the fi ber board baffl e, repeat steps 2 through 4 in reverse. Be sure the fi ber board baffl e and ceramic blanket are
pushed back fully into position and the ceramic blanket lays fl at.
Allen wrench
on retainer bolt
Figure 21A - Manifold tubes retaining bolt.
March 27, 2008
4100-I ACT WOOD INSERT
BRICK REPLACEMENT INSTRUCTIONS
Qty in Set
2
2
1
12
3
2
BAFFLE REMOVAL & INSTALLATION
First tube has larger holes
6
5
4
4
4
4
2
Use Part #832-0550 when ordering indi-
vidual brick and provide brick dimension
or copy this page and mark the desired
brick and take it to your authorized
dealer.
Figure 21B - Baffl e & Ceramic Blanket on top.
250-7201 Rev D
1
1 4
4
4
4 5 4
3
4
2
Ceramic Blanket
R
6
5
4
4
2-1/4"
2
6-1/8"
Baffle
Page 21