Brick Replacement; Baffle Removal - Quadra-Fire 2700-I Instruction Manual

2700-I WOOD INSERT (ACT)
BRICK REpLACEMENT INSTRUCTIONS
The firebox of your Quadra-Fire 2700-I Insert is lined with high
quality firebrick which has exceptional insulating properties.
There is no need for a grate, simply build a fire on the firebrick
floor.
1. Be certain coals are completely cold. Remove all old brick
and ash from unit and vacuum out firebox.
2. Remove new brick set from box and lay out to diagram as
shown.
. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks. Slide top
of bricks under clip on back of firebox wall and push bottom
of brick back.
5. Install side bricks. Slide top of brick under clips on side of
firebox and push the bottom of the brick until it is flush with
the side of the unit.
Nbr. Brick Size
1 9 x 4-1/2 x 1-1/4"
2 9 x 4-1/2 x 1-1/4" with hole
 4-1/2" x 4-1/2 x 1-1/4
4 see diagram
5 see diagram
6 7-/4" x 2-1/2 x 1-1/4"
Use Part No. 82-0550 when ordering individual brick and
provide brick dimension or copy this page and mark the
desired brick and take it to your authorized dealer.
BAFFLE REMOVAL & INSTALLATION
1. Remove all ash from firebox, and extinguish all hot embers
before disposal into a metal container.
2. Remove ceramic blanket and baffle together.
. With a /16 Allen wrench, remove the front manifold tube
retainer bolts on the air channel under the end of the front tube.
See Figure 20.1. NOTE: Soak the bolts with penetrating oil
for at least 15 minutes before trying to remove it.
4. To remove manifold tube, slide the tube to one side until one
end is out of its hole. Then, while lifting that end of the fiber
board baffle, pull tube up over the air channel and out of hole
at the other end.
5. Slide fiber board baffle forward to front of stove and straight
out through door. See Figure 20.2.
6. To install the fiber board baffle, repeat steps 2 through 4 in
reverse. Be sure the fiber board baffle and ceramic blanket
are fully pushed back into position.
NOTE: Manifold tubes #1 and #2 have the same size air holes,
however tube # has smaller air holes.
Page 20
qty
11
1
1
2
Figure 20.1
2
2
Figure 20.2 - Manifold tubes in roof of firebox.
Figure 20.3 Baffle & Ceramic Blanket on top.
7007-161H
6
1
1
5
1
4
1
1
9.0"
1.5
2
2-5/16"
9.0"
4
4-1/2"
7-7/16"
Tube One
Tube Two
Attach on right side
Ceramic Blanket
Baffle
6
2
1
1

5
1
1 4
1
1
4-1/2"
7-/8
"
5
4-1/2"
5-1/16
"
September 1, 2008
R