Installing Windows Server 2003 - Fujitsu PRIMERGY BX620 S4 User Manual

Chapter 4 Manual OS Installation

4.2.4 Installing Windows Server 2003

1
Create driver disks.
Prepare necessary drivers before installing Windows Server 2003.
Some drivers are created from the PRIMERGY Startup Disc. For how to create driver disks, refer
to "4.1 Creating Driver Disks" ( pg.70).
2
Connect the USB CD/DVD drive and USB floppy disk drive to the Server Blade.
Use the Display/USB Extension Cable to connect the USB CD/DVD drive and USB floppy disk
drive. For more information on the connection procedure, refer to "Start Guide".
3
Turned on the Server Blade and configure RAID. If RAID is not required to be
configured, proceed to step 4.
Turn on the server to display the following message and press the [Ctrl] + [C] key to start up the
BIOS Utility.
Press Ctrl C to start LSI Logic Configuration Utility
The array system is configured by using BIOS Utility. For more details, refer to the manual in the
Array Controller Document & Tool CD.
Turn off the Server Blade after configuring the array system.
4
Insert the Windows Server 2003 CD/DVD.
Turn on the Server Blade and insert the Windows Server 2003 CD/DVD immediately into the
CD/DVD drive. Check there are no floppy disks in the floppy disk drive. When the active area is
specified on the hard disk, the following message appears.
Press any key to boot from CD...
Pressing any key while this message is displayed boots the system from the CD/DVD.
5
The [Windows Server 2003 Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
Press F6 if you need to install a third party
SCSI or RAID driver...
86
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.