Preparation On The Server; Installing Internal Options - Fujitsu PRIMERGY BX620 S4 User Manual

Chapter 2 Checking before OS Installation

2.1 Preparation on the Server

Before starting installation, install internal options to the server and perform
necessary hardware settings.

2.1.1 Installing Internal Options

Before installing internal options, refer to each option manual and be sure to read the notes.
Install the internal options in the Server Blades, and install the blades and options in the Chassis. For
details on the internal options, refer to the following:
• Installing internal options to Server Blades
→ "Chapter 7 Installing Internal Options" ( pg.171)
• Installing blades, Power Supply Unit, and Fan Unit in the Chassis
→ "Chapter 4 Installing Options" in "BX600 S3 Blade Server System Unit Hardware Guide"
Cautions for installing a Storage Blade
If an array has already been configured in the internal hard disk unit that is installed in the Storage
Blade, delete the array configuration when installing the OS.
Set an array configuration again after OS installation.
Cautions for installing an external storage system
When installing an external storage system such as the ETERNUS series in the Chassis, make sure to
turn the external storage system power on after the OS installation has completed.
Make sure the power is not turned on when installing the OS by taking precautions such as
disconnecting the power cable.
LAN cable
Be sure to connect the LAN cable when the server is not connected to the Internet.
Connecting to the Internet during setup can cause security problems. Do not connect to the Internet
until the setup completes.
If the OS is installed or applications are automatically installed without connecting the LAN cable, an
error may be recorded in the event viewer after the setup process finishes.
Cautions for installing an expansion card
When using an expansion card, read the notes on the expansion card.
34