Fujitsu PRIMERGY BX620 S4 User Manual page 3

Content of this manual
This Server Blade cannot be installed on chassis other than PRIMERGY BX600 S2/BX600 S3.
This manual explains about installing the Server Blade on a PRIMERGY BX600 S3 Chassis.
If installing it on a PRIMERGY BX600 S2 chassis, the following restrictions are imposed.
• Read "BX600 S2 Blade Server System Unit Hardware Guide" before use. (Refer to the Document &
Tool CD provided with the chassis.)
• Do not install on the chassis Server Blades slot 4 and slot 10.
If installed on chassis Server Blades slot 4 and slot 10, the device may not operate correctly.
• Four internal LAN ports out of six of this Server Blade cannot be used.
• Do not install the Server Blade slot with 4 Gbit/s FC I/O Module (PG-FCD201) installed on BX600
S2 chassis. This will cause a failure.
When installing a Server Blade with a FC expansion board installed on the BX600 S2 chassis, use the
4 Gbit/s FC I/O Module (PG-FCD102).
• Management Blade firmware may be required to be updated.
For information about the combination of supported firmware, refer to the Fujitsu PRIMERGY
website (http://primergy.fujitsu.com), and download or update an appropriate firmware.
If an appropriate firmware is not applied, this product may not operate properly.
PRIMERGY BX620 S4 Server Blade User's Guide
3