Adjustment - Panasonic WV-SF549 Installation Manual

Adjustment

Perform the following procedures before adjusting the camera angle.
Detach the inner dome from the camera by
picking the front and rear sides.
Note:
• Do not touch the lens.
z
Adjust the camera angle. When determining the camera angle, repeat fine adjustments by
gradually moving the panning table, tilting table, and azimuth adjustment ring.
Horizontal position (Panning)
Loosen the panning lock screw, rotate
the panning table to adjust the pan
direction. (Adjustable range: 350 °)
Panning is possible within the range
of 180 ° (when panning clockwise)
and 170 ° (when panning counter-
clockwise). After adjustment, tighten
the panning lock screw to fix the pan-
ning table.
(Recommended tightening torque:
0.39 N·m {0.29 lbf·ft})
30
Pick the portion marked
in the illustration as well
as the opposite side.
Panning table
Panning lock
screw [LOCK]
Counterclockwise panning
end marker: Rotation within
the range of 170 °
SF549 SF548
Home position
* The position where the home
position markers are aligned
Home position
markers
Clockwise panning end
marker: Rotation within
the range of 180 °
K