Focus Or Flange-Back Adjustment - Panasonic WV-BP100 Operating Instructions Manual

DC :
FOCUS OR FLANGE-BACK ADJUSTMENT
The mounted lens is one of the lenses listed on
pages 9,10 and 11 or one that requires the DC
control signal for auto iris control.
VIDEO :
The mounted lens requires video signal for auto
iris control.
Note :
Refer to item (5) on page 5 for the lens selection
switch.
Screw
The following adjustment should be made by
qualified service personnel or system installers.
1. Loosen screws on the flange-back adjusting ring.
Screw C-mount Lens
2. Turn the flange-back adjusting ring to the desired
position.
Caution:
Do not turn this ring too much to
counterclockwise as this could damage the
inner glass and CCD image sensor.
3. Tighten the screws on the flange-back adjusting
ring.
- 15 -