Advertisement
FOCUS OR FLANGE-BACK ADJUSTMENT
The following adjustment should be made by qualifi-
ed service personnel or system installers.
1. Loosen
the screw
on
the flange-back adjusting
ring.
C-mount
lens
Flange-back
CS mount lens
adjusting ring
Focus adjust for
CS mount lens
Focus adjust for
C-mount lens
. Turn the flange-back adjusting ring to the desired
2
position,
CAUTION:
Do not turn this ring too much to
counterclockwise
as this could dam-
age the inner glass and CCD
image
sensor.
3. Tighten
the screw
on the flange-back adjusting
ring.
a fee
SETUP OF SYNC SELECTION SWITCH AND
GEN-LOCK TERMINATION
SWITCH
The
following
setup
should
be made
by qualified
service personnel or system installers.
1, Remove
the one screw holding the cover of the
switches and remove the cover.
. Set the SYNC Selection Switch (INT/LL) (14) to
the desired position,
. Set
the
Gen-lock
Termination
Switch
(G/L 75
ohms,
ON/OFF)
(13)
to the desired
position.
. Reinstall
the cover and secure the cover with the
original screw,
PRECAUTION OF FLICKER
When
the
camera
is aimed
at objects which
are
illuminated
by fluorescent
lamp,
picture
may
have
flicker,
Advertisement
