Attaching the dome cover
Attach the dome cover to the camera.
The following procedure is required when using WV-SF549 or WV-SF548. Refer to page 35 when
using WV-SF539 or WV-SF538.
z
Attach the inner dome to the camera in the
same manner as the procedure in page 30.
Make sure that the tilting lock screws of
the camera and the holes on the inner
dome are correctly fit together.
x
Attach the dome cover using the bit for
tamperproof screw (accessory).
(Recommended tightening torque:
0.59 N·m {0.44 lbf·ft})
c
After the installation is complete, remove
the cover film from the dome section.
v
Push down the auto focus (AF) button with
a ballpoint pen to adjust the focus again.
Refer to page 30 for further information
about adjustment.
34
SF549
Auto focus (AF)
button
SF548