Yamaha VX500SXBC Service Manual page 81

1 Wire harness
2 50 mm (1.97 in)
3 Make sure that the oil tank
cap and oil breather hose do
not touch each other.
4 Route the fuel breather hose
along the upper of the main
harness.
5 Route the oil breather hose
along the upper of the main
harness.
6 Install the tail / brake light
lead behind the instrument
panel.
7 Holder
8 Clip
9 To tail / brake light
10 50 mm (1.97 in)
11 Fuel tank
12 Compression spring
13 Clip
14 Fuel sender coupler
15 Oil level switch coupler
16 Fuel hose
17 Pulser hose
18 Oil hose
19 Wire harness
20 To the conduction
21 Fasten the wire harness and
starter cable with a plastic
clamp. Route the wire
harness and starter cable
through the slot on the intake
silencer.
22 Starter cable
23 CDI unit
24 Carburetor switch coupler
25 Water temperature sensor
coupler
26 Starter relay coupler
27 CDI unit
28 CDI magneto coupler
29 Coolant breather hose
30 To the reservoir tank
CABLE ROUTING
–77–
SPEC