Yamaha VX500SXBC Service Manual page 79

1 Fasten the carburetor switch,
water temperature sensor
lead, coolant hose, wire lead
and battery negative lead
with a plastic clamp.
2 Clamp
3 Fasten the ignition coil and
starter cable with a plastic
clamp.
4 Fasten the wire lead, battery
negative lead and coolant
hose with a plastic clamp.
5 Cap (without electlic starter
model)
6 Fasten the coolant hose with
a plastic clamp.
7 Route the battery lead along
the behind coolant hose.
8 Fasten the wire lead, battery
negative lead and coolant
hose with a plastic clamp.
9 Starter relay sub lead
10 Wire lead
11 Wire negative lead
12 To starter relay
13 To battery negative lead
14 To reverse gear
15 Gear position switch coupler
16 Route the main switch
harness along the under of
the oil and fuel breather hose.
17 Starter relay lead
18 Brake hose
19 Oil tank
20 Route the parking brake
cable along the
under of the oil breather
hose.
21 Main switch assembly
22 Starter cable assembly
23 Oil pump cable
24 Throttle cable
25 Oil level gauge
26 Variable resistor
27 Variable resistor coupler
28 Parking brake cable
29 Ignition coil
30 Carburetor heating lever
31 Carburetor
32 Coolant hose
33 Speedometer cable
34 Under 50 mm (1.97 in)
35 Fasten the speedometer
cable and wire harness with
a plastic clamp.
CABLE ROUTING
–75–
SPEC