Yamaha VX500SXBC Service Manual page 73

1 Make sure that the oil tank
cap and oil breather hose do
not touch each other.
2 Route the fuel breather hose
along the upper of the main
harness.
3 Route the oil breather hose
along the upper of the main
harness.
4 Install the tail / brake light
lead behind the instrument
panel.
5 Holder
6 Clip
7 To tail / brake light
8 50 mm (1.97 in)
9 Fuel tank
10 Spring compression
11 Clip
12 Fuel sender coupler
13 Oil level switch
14 Oil hose
15 Pulser hose
16 Fuel hose
17 To carburetor left side
18 To carburetor right side
19 Fasten the wire harness with
a plastic clamp.
Route the wire harness
through the slot on the intake
silencer.
20 Air vent hose (ECC model)
21 CDI unit and ECU
22 Fasten the wire harness with
a plastic clamp.
Route the wire harness
through the slot on the intake
silencer.
23 Carburetor switch coupler
24 Water temperature sensor
coupler
25 Starter relay coupler
26 ECU (ECC model)
27 CDI unit
28 TPS coupler (600 cc model)
29 Solenoid coupler
30 CDI magneto coupler
31 Wire harness
CABLE ROUTING
–69–
SPEC