DRIVE CHAIN HOUSING/JACKSHAFT
–23–
INSTALLATION
During installation, pay attention to the fol-
lowing point:
A Properly install the rubber seal onto the drive
chain housing, making sure that these are no
gaps.
B Make sure that the bearing seals face towards
the drive chain, as shown.
C Be sure to install the spacers in their original
positions of the brake disc and jackshaft will
stick.
D 0.1 X 0.5 mm (0.004 X 0.020 in)
: ESSO beacon 325 grease or Aero-
shell grease #7A
Drive chain housing and jackshaft installa-
tion steps refer to the "WITH OUT REVERSE
MODEL".
JACKSHAFT
INSPECTION
1. Measure:
S Brake disc thickness a
Out of specification ! Replace.
Minimum thickness:
10 mm (0.39 in)
Measuring point 1 X 3
POWR
TR