3.
Install the fixed holding tube block down to the position as shown in the figure, then pull the OHP film off to remove.
OHP Film
Note:
When installing the fixed holding tube block, do not damage the switch shown in the figure.
HELP12
Grease (F-10):
J-6082-631-A
Adhesive bond (B-40): J-6082-614-A
1.
Apply the grease (F-10) to the instruction part of the float ring.
2.
Attach the float ring, and apply the adhesive bond (B-40) to the three screws and tighten them as shown in the figure.
Apply the
adhesive
bond (B-40)
SAL100M28 (MACRO 2.8/100) (100mm F2.8 Macro)
Torque Ring Support Barrel
Orient the focus range stopper as illustrated.
Switch
Apply the grease
(F-10) (All circumference)
Apply the
adhesive bond (B-40)
Apply the grease
(F-10) (All circumference)
Torque Spring
Install the fixed holding tube block while
slightly warping it from the both sides.
HELP