Skoda Superb Owner's Manual page 49

The window can be completely opened automatically by briefly pressing the but-
ton as far as the stop. Renewed pressing of the button causes the window to
stop immediately.
Closing
›
Pull gently on the top edge of the corresponding button and hold until the win-
dow has moved into the desired position. Releasing the button causes the win-
dow to stop immediately.
The window can also be fully closed automatically by pulling the button up to the
stop. Renewed pulling of the button causes the window to stop immediately.
Force limit

First read and observe the introductory information and safety warn-
ings on page 44.
The electrical power window system is fitted with a force limiter. It reduces the
risk of bruises or injuries when closing the windows.
If there is an obstacle, the closing process is stopped and the window goes down
by several centimetres.
If the obstacle prevents the window from being closed during the next 10 sec-
onds, the closing process is interrupted once again and the window goes down by
several centimetres.
If you attempt to close the window again within 10 seconds of the window being
moved down for the second time, even though the obstacle was not yet been re-
moved, the closing process is only stopped. During this time it is not possible to
automatically close the window. The force limiter is still switched on.
The force limiter is only switched off if you attempt to close the window again
within the next 10 seconds - the window will now close with full force!
If you wait longer than 10 seconds, the force limiter is switched on again.
1)
Convenience opening and closing the windows with the button
locking the vehicle or turning off the ignition and opening the driver's or front passenger's door.
46
Using the system

The windows can be operated by the locking or unlocking.
The prerequisite for ensuring that the convenience operating feature correctly is
the automatic opening/closing of all windows is operational.

Opening can take place in one of the following ways.
›
›
›
›
Closing can take place in one of the following ways.
›
›
›
›
›
You can interrupt the opening or closing process for the windows immediately by
releasing the key or the the button
Convenience opening or closing the window using the key in the driver's lock is
only possible within 45 seconds after locking the vehicle.


The automatic power windows do not work if the vehicle battery was disconnec-
ted and connected while a window is open. The system must be activated.
Activation sequence:
is possible immediately after un-
A
Window convenience operation
First read and observe the introductory information and safety warn-
ings on page 44.
Press and hold the symbol button  on the key.
Hold the key in the driver's lock in the unlock position.
Press and hold the upper part of the central locking button in the driver's
door » page 36.
Hold the button 1) in the opening position
A
Press and hold the symbol button  on the key.
Hold the key in the driver's lock in the lock position.
Press and hold the lower part of the central locking button
driver's door.
Hold the button 1) in the closing position
A
In the KESSY system, hold a finger on the sensor
A
Operational faults
First read and observe the introductory information and safety warn-
ings on page 44.
» Fig. 25 on page 45.
» page 36 in the
» Fig. 25 on page 45.
» Fig. 14 on page 34.
1
and interrupting the locking/unlocking.

