Skoda Superb Owner's Manual page 161

The cruise control system cannot be activated when the selector lever is in po-
■
sitions P , N or R (vehicles with automatic transmission).
The cruise control system may automatically switch off when some brake assist
■
systems (e.g. ESC) intervene, when the maximum permissible engine speed is ex-
ceeded, etc.
Activating/deactivating

First read and observe the introductory information and safety warn-
ings on page 157.
Activating
›
Move switch » Fig. 135 into the ON position.
A
Deactivating
›
Move switch » Fig. 135 into the OFF position.
A
Storing and maintaining speed

First read and observe the introductory information and safety warn-
ings on page 157.
›
Activate the cruise control system
›
Drive at the desired speed.
›
Push the rocker button into the SET/-
B
After you have released the rocker button
you have just stored is kept constant without having to depress the accelerator.
158
Driving
Fig. 135
Operating lever: Cruise control
system controls
» page 158.
» Fig. 135 on page 158 position.
from the SET/- position, the speed
B
Changing the stored speed

First read and observe the introductory information and safety warn-
ings on page 157.

Increasing the speed with the rocker button
›
Push the rocker button into the RES/+
B
If the rocker button is held in the RES/+ position, the speed will increase continu-
ously. Release the rocker button once the desired speed is reached. The set
speed is then stored in the memory.
Decreasing the speed using the rocker button
The stored speed can be reduced by pushing the rocker switch
SET » Fig. 135 on page 158 position.
If the rocker button is pressed and held in the SET/- position, the speed will de-
crease continuously. Release the rocker button once the desired speed is
reached. The set speed is then stored in the memory.
If the rocker button is released at a speed of less than approx. 25 km/h, the speed
is not stored and the memory is erased. Once the speed of the vehicle has in-
creased to more than approx. 25 km/h, the speed must then be stored again by
pushing the rocker button
B
Increasing the speed with the accelerator
›
Depress the accelerator pedal.
Releasing the accelerator pedal will cause the speed to drop again to the set

speed.
Decreasing the speed with the brake pedal
The speed can also be reduced by depressing the brake pedal, which temporarily
deactivates the system » page
Switching off temporarily

First read and observe the introductory information and safety warn-
ings on page 157.
The cruise control system can be temporarily deactivated by pushing the switch

» Fig. 135 on page 158into the spring-mounted CANCEL position or by depress-
A
ing the brake or clutch pedal.
The set speed remains stored in the memory.
B
» Fig. 135 on page 158 position.
B
B
into the SET/- position.
158.
into the

