Inertia Reels And Belt Tensioners - Skoda Superb Owner's Manual

Seat belt height adjuster on the front seats

First read and observe the introductory information and safety warn-
ings on page 173.
The seat belt height adjuster makes it possible to adjust the routing of the front
seat belts in the area of the shoulder to the body size.
›
Press the height adjuster and move up or down in the desired direc-
tion » Fig. 148.
›
Then pull firmly on the belt to ensure that the seat belt height adjuster has cor-
rectly locked in place.

Inertia reels and belt tensioners


Introduction
This chapter contains information on the following subjects:
Inertia reels
Belt tensioners
Inertia reels

First read and observe the introductory information given on page 176.
Each seat belt is equipped with an inertia reel.
176
Safety
Fig. 148
Front seat: Seat belt height ad-
juster
176
176
When pulling slowly on the seat belt, the belt can move freely. When pulling
sharply on the seat belt, the movement is locked by the inertia reel.
The belts also lock when full braking, when the car accelerates, when driving
downhill and when cornering.
WARNING
If the seat belt does not lock when pulling sharply on it, have it inspected im-
mediately by a specialist garage.
Belt tensioners

First read and observe the introductory information given on page 176.
The safety for the driver, front passenger and passengers on the outer rear seats
who are wearing their seat belts, is enhanced by the belt tensioners fitted to the
inertia reels on the front and rear external three-point seat belts.
The three-point seat belts are automatically tensioned in the event of a frontal
collision of a certain severity. The belt tensioners can also be deployed if the seat

belts are not fastened.
The fastened three-point seat belts are automatically tensioned in the event of a
frontal or side collision of a certain severity.
Belt tensioners are not activated in the event of minor frontal collisions, side and
rear-end collisions, in the case of a rollover and also not in accidents in which no
major forces are produced from the front.
WARNING
Any work on the belt tensioner system including removal and installation of
■

system components because of other repair work, must only be carried out by
a specialist garage.
The protective function of the system is only adequate for a single accident.
■
If the belt tensioners have been deployed, it is then necessary to replace the
entire system.

