Skoda Superb Owner's Manual page 111

Switching on/off
Fig. 109 Button for switching on/off the system directly on the operating
part of the air conditioning/Climatronic

First read and observe the introductory information and safety warn-
ings on page 107.
The auxiliary heating (aux. heating) can be switched on/off as follows.
Manually switching on
using the button on the operating part of the manual air conditioning/Clima-

tronic. The warning light in the button lights up
by using the radio remote control

Manually switching off
using the button on the operating part of the manual air conditioning/Clima-

tronic. The warning light in the button goes out
by using the radio remote control

After switching off the auxiliary heating, the coolant pump runs for a short period.
Automatic switching on/off
The following menu items can be selected from the Aux. heating menu item in
the information display » page 28 (depending on the vehicle equipment):
■ Day of the week - set the current day of the week;
Running time - Set the required running time in 5 minute increments. The run-
■
ning time can be 10 to 60 minutes.
■ Mode - Set the desired heating/ventilation mode;
108
Using the system
» Fig. 109;
» page 109.
» Fig. 109;
» page 109.
Starting time 1, Starting time 2, Starting time 3 - for each pre-set time, the day
■
and the time (hour and minute) can be set for switching on the auxiliary heating
and ventilation. An empty position can be found between Sunday and Monday
when selecting the day. If this empty position is selected, the activation is per-
formed without taking into account the day.
■ Activate - Activate pre-set mode;
Deactivate - Deactivate pre-set mode;
■
Factory setting - Restore factory setting;
■
■ Back - Return to main menu
Only one programmed pre-set time can be active.
The last programmed pre-set time remains active.
After the auxiliary heating (aux. heating) automatically activates at the set time, it
is necessary to pre-set a time again.
If the menu item Back is selected or no changes are made on the display for lon-
ger than 10 seconds, the set values are stored, but the pre-set time is not activa-
ted.
The system switches itself off at the end of the running time set under the menu
item Running time.
Note
An indicator light on the button  » Fig. 109
running.
is illuminated when the system is
