Chevrolet Light Duty Truck 1973 Service Manual page 227

Fig. 6—Shock Absorber—G-10, 20, 30
STABILIZER SHAFTS
Refer to figures 9, 10 and 11 for specific rear stabilizer
shaft mounting on C and P models.
Replacement
1. Raise vehicle on hoist and support rear axle.
2. Remove nut, washer and grommet from link bolt at
the frame side member on each side.
3. Withdraw link bolt, washers, grommets and spacer.
REAR S U S P E N S IO N A N D DRIVELINE
4. Remove brackets from anchor plates by removing
attaching screws.
5. Remove stabilizer shafts.
. Reverse above steps to install stabilizer shaft. On
6
installation, position shaft so parking brake cable is
routed over stabilizer.
7. Torque all bolts to specifications.
See CAUTION on page 1 of t h i s
CAUTION:
s e c t i o n , regarding s ta b i l i z e r fasteners.
. Lower hoist and remove vehicle.
8
4-3
LIGHT DUTY TRUCK SERVICE MANUAL