Chevrolet Light Duty Truck 1973 Service Manual page 135

channel. See figure 40. Disengage roller from
channel.
5. Tilt window outboard and move until other roller
can be removed from channel.
6. Raise window up and out.
7. Reverse above procedure for installation.
WINDOW REGULATOR ASSEMBLY—FIG. 40
Replacement
1. Remove trim pad, stationary glass, and window
glass as outlined earlier.
2. Remove screws attaching regulator assembly to
door inner panel.
3. Remove regulator assembly through opening in
door.
Fig. 39—Glass Run Channel
4. Install regulator by reversing above procedure.
Lubricate regulator gear with lubriplate or
equivalent.
LOCKS, HANDLES AND RODS
Lock Assembly—Fig. 41
Replacement
1. Remove window regulator handle and remote
control push button knob.
2. Remove trim pad.
3. Disengage three clips which retain control rods to
lock assembly.
a. Inside handle control rod.
b. Remote control lower rod.
c. Outside handle control rod.
4. Remove screws retaining lock assembly to door
panel, then remove lock assembly.
5. Install lock by reversing above procedure. Be sure
to replace all clips removed with new clips on
installation.
Inside Handle—Fig. 41
Replacement
1. Remove regulator handle, remote control knob and
trim pad as outlined previously.
2. Disconnect control rod from inside handle by
removing clip as shown in figure 41.
3. Remove inside handle by removing four screws
which secure handle to door panel.
4. Replace handle by reversing above procedure.
Install new clip when installing control rod.
BODY I B - 1 5
LIGHT DUTY TRUCK SERVICE MANUAL