Chevrolet Light Duty Truck 1973 Service Manual page 140

1B-20 BODY
Fig. 53—Window Glass and Regulator— (06 Only)
8. Unclip and remove inner and outer seal assemblies.
9. Remove screws connecting window regulator
assembly to endgate, figure 53, and remove
regulator.
10. From inside the endgate, remove the nuts fastening
the outside handle to endgate and remove the
outside handle. See figure 54.
NOTE: If equipped with power tailgate
window, detach wiring harness from motor.
11. Remove side bolts connecting left and right glass
channels to endgate and remove channels.
12. Remove side latch bolts and remove side latches
with control rods. See figure 52.
NOTE: Detach wiring harness from R. H.
latch if so equipped.
13. Separate side latch from control rod by pulling
control rod thru nylon guide.
14. Reverse the above procedure for reassembly and
installation.
Adjustments
Loosen bolts, adjust at either endgate hinge position or
endgate latch, then retighten bolts.
Fig. 54—Outside Handle (06 and 14)
ENDGATE ASSEMBLY—
(14) MODELS ONLY
Replacement
1. Lower endgate, then remove four bolts securing
hinge to body on each side. See figure 55.
2. Disconnect torque rod anchor plate on each side. It
is necessary to remove lower bolt only, then let
plate swing down. See figure 59.
3. With an assistant, raise endgate part way, then
LIGHT DUTY TRUCK SERVICE MANUAL