Chevrolet Light Duty Truck 1973 Service Manual page 154

1 B -34 BODY
a. Pull on loose ends until each is within 2" of its
respective upper corner.
b. Pull on loop until cord is within 2" of the upper
corners.
c. Finish seating corners by simultaneously pulling
on both ends of the cord at each corner. This
will insure proper positioning of the critical
upper corners.
DOOR ADJUSTMENTS
Doors can be adjusted for alignment of clearance in the
cab door opening, and for proper latching. Door
alignment adjustments are made at the striker bolt, and
at door hinges. The door, when properly located in door
opening, will have equal clearance around its perimeter.
d. Seal windshield to weatherstrip and weatherstrip
to body.
SWINGOUT WINDOW
Removal
1. Swing out the window. See figure 11G.
2. Remove screws retaining latch to body.
3. Remove window hinge retaining screws and
window.
4. Remove latch from glass.
Installation
1. Install latch to glass using escutcheon, spacer,
washer, latch and screw. Torque to specifications.
2. Place window into opening and install hinge
retaining screws and window.
3. Install latch to glass.
LATCH SWINGOUT WINDOW
Replacement
1. Swing out the window.
2. Remove latch to body and latch to window screws
and remove latch.
3. Reverse above steps for installation.
FRONT D O O R
The door should be adjusted in the opening so the edge
of the door across the top and also at the lock side is
parallel with the body opening as nearly as possible.
Hinge Adjustment
Door hinge bolt holes are oversized to make adjustment
Fig. 11G—Swingout Window
LIGHT DUTY TRUCK SERVICE MANUAL