Chevrolet Light Duty Truck 1973 Service Manual page 167

PASSENGER SEAT—MOUNTING
BRACKETS
Removal
1. Remove seat and brackets from seat riser. See
figure 39G.
2. Remove brackets from seat.
Installation
1. Install brackets to seat. Torque to specifications.
2. Install seat to seat riser. Torque to specifications.
SEAT RISER
Removal
1. Remove seat and mounting bracket as an assembly.
2. Remove riser from floor.
Installation
1. Install riser to floor. Torque bolts to specifications.
2. Install seat to riser. Torque bolts to specifications.
BENCH SEATS—FIGS. 40G, 41G
Seat and/or Seat Support
Removal
1. Remove bolts securing seat legs to floor.
2. Remove seat assembly.
NOTE: After removing the rear seat, reinstall
the bolts into the anchor nuts to seal the
openings from dirt and foreign matter.
3. Remove legs and support assembly.
Fig. 39G—Passenger Seat
installation
1. Attach leg and support assembly to seat. Torque to
specifications.
2. Attach seat belts. Torque bolts to specifications.
Shoulder of Bolt must bottom on
CAUTION:
weld nu t.
3. Attach seat to floor. Torque bolts to specifications.
CARE AND CLEANING OF SEATS
Instructions on care and cleaning of interior soft trim
may be found in "C-K M odels-Seats", earlier in this
section.
Fig. 40G—Bench Seat 2nd or 3rd Position
Fig. 41G—Bench Seat 4th Position
BODY 1 B-47
LIGHT DUTY TRUCK SERVICE MANUAL