Dbs Receiver Control; Situate And Connect Controller - JVC HR-DD840U Instructions Manual

20
EN
DBS Receiver
Control
Suggested Location
Place the DBS (Direct Broadcast Satellite) receiver on top of the
VCR. Attach the VCR's Controller to the top of the VCR with the
Controller's transmitter pointed towards the DBS receiver's
remote sensor.
Attention:
The Controller can also control a cable box. If both a DBS
receiver and a cable box are used, position the controller so its
signal reaches the remote control sensors of both the DBS
receiver and cable box.
Your VCR
DBS receiver
Controller
Your VCR
About Your DBS Receiver
This VCR has two separate methods to control your DBS Receiver.
The VCR's Wireless Remote Control Unit can control your
DBS Receiver.
This eliminates the need for a separate DBS Receiver Remote
Control Unit.
The VCR's Controller can also control your DBS Receiver.
This allows the VCR to change your DBS receiver's channel
number during timer recording.
Each method must be set up separately. To set up the VCR's
Remote Control unit, refer to page 57. To set up the Controller
go to page 21.
DBS receiver
Controller
(suggested locations)
Transmitter
Connected
to VIDEO/
Connected to
AUDIO IN
ANTENNA IN
CABLE
BOX
INITIAL SETTINGS (cont.)
The following procedure is required if you receive satellite channels
through a DBS (Direct Broadcast Satellite) Receiver. The Controller
allows the VCR to automatically switch the DBS Receiver's channels
during timer recording.
The VCR can control the DBS Receiver during timer recording
using its Controller.
NOTES:
The Controller can automatically change the DBS Receiver
channels when the VCR has been programmed using On-
Screen Timer Programming (
Because satellite programming does not use PlusCode; the
Controller can not change the DBS Receiver channels during
VCR Plus+ Timer Recording.
If a cable box is also used it is recommended that you
connect the DBS receiver to your VCR's A/V inputs and the
cable box to your VCR's antenna input.

Situate And Connect Controller

SITUATE CONTROLLER
1
Place the Controller so that the path between its
transmitter and the DBS receiver's remote sensor is
unobstructed.
ATTACH CONTROLLER
2
Fasten securely using the supplied adhesive strips.
CONNECT DBS RECEIVER
TO VCR
3
The connection method depends on the type of DBS
receiver you have.
If your DBS receiver has AUDIO and VIDEO OUT
connectors . . .
. . . connect them to the AUDIO and VIDEO IN
connectors on your VCR; select the correct external
input mode as described in step 4, 5, 9 – 11 on page 50
& 51. Set the VCR to channel "AU" to use the DBS
receiver.
If your DBS receiver doesn't have AUDIO and VIDEO
OUT connectors . . .
. . . connect the antenna output connector on the DBS
receiver to the ANTENNA IN connector on the rear of
your VCR.
Set the VCR's tuner to the same channel as the DBS
receiver's RF output. (See page 21 also.)
NOTE:
When connecting your DBS receiver refer to its
instruction manual.
CONNECT CONTROLLER
TO VCR
4
Connect to the CABLE BOX connector on your VCR.
pg. 44).