Set Dbs Receiver Brand - JVC HR-DD840U Instructions Manual

22
EN
NUMBER
MENU
NOTES:
It is possible that the Controller will not work with all types of
DBS receiver.
If your DBS receiver doesn't respond to the code, you can't
use the Controller to change satellite channels. In this case,
make sure to leave the DBS receiver turned on and tuned to
the proper channel before the scheduled start of timer
recording.
The VCR can only change the satellite channel through the
Controller during timer recording.
If your DBS receiver is one that can't be operated with a
remote control (because it has no remote sensor), you can't
use the Controller to change its channels. Make sure to leave
the DBS receiver turned on and tuned to the proper channel
before the scheduled start of timer recording.
For customers in U.S.A.: If you are unable to set the Control-
ler, please contact JVC toll free at 1-800-252-5722.
q
1 2 3
6
4 5
7 8 9
0
CH
OK
TIME SCAN
INITIAL SETTINGS (cont.)

Set DBS Receiver Brand

TURN ON DBS RECEIVER
1
Select a channel other than channel 55, 100 or 205 on
your DBS receiver.
ACCESS DBS RECEIVER
BRAND SET SCREEN
2
At the Custom Set screen,
press CH 5 ∞ or TIME
SCAN 5 ∞ to move the
highlight bar (arrow) to
"DBS RECEIVER BRAND
SET", then press OK.
ENTER DBS RECEIVER
BRAND
3
Press the appropriate
NUMBER keys to enter the
DBS Receiver Code from
the following list, then
press OK.
The unit is pre-set to code
80 (RCA) when shipped.
BRAND
RCA (DSS)
SONY (DSS)
PRIMESTAR
ECHOSTAR
If the DBS receiver's channel changes as follows,
setting is complete:
RCA or SONY [ 205
PRIMESTAR [ 55
ECHOSTAR [ 100
After OK is pressed, the program currently received
through the DBS receiver will appear for about 10
seconds.
RETURN TO NORMAL
SCREEN
4
Press MENU as many times as necessary.
CUSTOM SET
OVERRIDE
AUTO CLOCK SET
LANGUAGE SELECT
VCR PLUS+ SET-UP
DBS RECEIVER OUTPUT
=DBS RECEIVER BRAND SET
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END
DBS RECEIVER BRAND SET
80
PRESS NUMBER KEY (0-9)
THEN (OK)
PRESS (MENU) TO END
CODE
80
81
90
91