Insert Editing - JVC HR-DD840U Instructions Manual

52
EN

Insert Editing

Recorder
Audio/Video cable
(supplied)
Player
C.RESET
Your VCR
TIME SCAN SHUTTLE
q
Audio/Video
signal
Another VCR
1 2 3
6
4 5
7 8 9
0
PAUSE
TIME SCAN
Insert editing replaces part of the recorded scene with new
material. Both the picture and Hi-Fi audio soundtrack are
replaced with new ones, while the normal audio soundtrack
remains unchanged. If you wish to change the normal audio
track as well, use the audio dubbing function simultaneously.
Use your VCR as the recorder.
Source tape
Before insert editing
Recorded tape
After insert editing
MAKE CONNECTIONS
1
Connect the player's VIDEO OUT and AUDIO OUT
connectors to your VCR's VIDEO IN and AUDIO IN on
the front panel.
SET INPUT MODE
2
Press NUMBER key "0". "AU" appears in place of a
channel number.
Be sure to select the correct AUX input connector at
the Aux Input screen. (To select the correct AUX input
connector, follow steps 4, 5, 9 – 11 from the "Edit
From A Camcorder" section
LOCATE END POINT
3
Load the recording cassette into your VCR, and play it
back to determine the edit-out point (the end of the
segment to be replaced) using the JOG/TIME SCAN
SHUTTLE controls or TIME SCAN ™£ and PAUSE.
RESET THE COUNTER
4
Press C.RESET to change the counter display to
"0 00 00 ".
H M S
LOCATE START POINT
5
Determine the edit-in point (the beginning of the
segment to be replaced) using the JOG/TIME SCAN
SHUTTLE controls or TIME SCAN ™£ and PAUSE.
Be sure to engage the Still mode at the edit-in point.
EDITING (cont.)
Normal audio
track
Video/Hi-Fi
audio track
pg. 50).