Table of Contents
Advertisement
18
EN
DBS Receiver
Control
Suggested Location
Place the DBS (Direct Broadcast DBS) receiver on top of the
VCR. Attach the VCR's Controller to the top of the VCR with the
Controller's transmitter pointed towards the DBS receiver's
remote sensor.
Attention:
The Controller can also control a cable box. If both a DBS
receiver and a cable box are used, position the controller so its
signal reaches the remote control sensors of both the DBS
receiver and cable box.
Your VCR
Controller
Your VCR
About Your D BS Receiver
This VCR has two separate methods to control your DBS Receiver.
● The VCR's Wireless Remote Control Unit can control your
DBS Receiver.
This eliminates the need for a separate DBS Receiver Remote
Control Unit.
● The VCR's Controller can also control your DBS Receiver.
This allows the VCR to change your DBS receiver's channel
number during timer recording.
Each method must be set up separately. To set up the VCR's
Remote Control unit, refer to page 55. To set up the Controller
go to page 19.
Downloaded from:
https://www.usersmanualguide.com/
DBS receiver
Controller
(suggested locations)
D BS receiver
Transmitter
Connected
to VIDEO/
Connected to
AUDIO IN
ANTENNA IN
CABLE
BOX
IN ITIAL SETTIN GS (cont.)
The following procedure is required if you receive DBS channels
through a DBS (Direct Broadcast DBS) Receiver. The Controller
allows the VCR to automatically switch the DBS Receiver's channels
during timer recording.
The VCR can control the DBS Receiver during timer recording
using its Controller.
N O TES:
● The Controller can automatically change the DBS Receiver
channels when the VCR has been programmed using On-
Screen Timer Programming (
Because DBS programming does not use G-CODE; the
Controller can not change the DBS Receiver channels during
G-C
Timer Recording.
ODE
● If a cable box is also used it is recommended that you
connect the DBS receiver to your VCR's A/V inputs and the
cable box to your VCR's antenna input.
Situate And Connect Controller
SITUATE CO N TRO LLER
Place the Controller so that the path between its
1
transmitter and the DBS receiver's remote sensor is
unobstructed.
ATT ACH CO N TRO LLER
Fasten securely using the supplied adhesive strips.
2
CO N N ECT DBS RECEIVER
TO VCR
The connection method depends on the type of DBS
3
receiver you have.
If your D BS receiver has AU D IO and VID EO O U T
connectors . . .
. . . connect them to the AUDIO and VIDEO IN
connectors on your VCR; select the correct external
input mode as described in step 4 , 5 , 9 – 11 on page
48. Set the VCR to channel "AU" to use the DBS
receiver.
If your D BS receiver doesn't have AU D IO and VID EO
O U T connectors . . .
. . . connect the antenna output connector on the DBS
receiver to the ANTENNA IN connector on the rear of
your VCR.
Set the VCR tuner to the same channel as DBS receiver
RF output. (See page 19 also.)
N O TE:
When connecting your DBS receiver refer to its
instruction manual.
CO N N ECT CO N TRO LLER
TO VCR
Connect to the CABLE BOX connector on your VCR.
4
pg. 42).
Advertisement
Table of Contents
