Dial Plan - Alcatel Temporis IP150 Manual

DTMF method
sip_account.x.dtmf_transport_method
Unregister after reboot
sip_account.x.unregister_after_reboot_enable

Dial Plan

The dial plan consists of a series of dialing rules, or strings, that determine whether what
the user has dialed is valid and when the phone should dial the number.
Dialing rules must consist of the elements defined in the table below.
Element Description
x Any dial pad key from 0 to 9, including # and *.
[0-9] Any two numbers separated by a hyphen, where the second number is
greater than the first. All numbers within the range or valid, excluding #
and *.
x+ An unlimited series of digits.
, This represents the playing of a secondary dial tone (
the user enters the digit(s) specified or dials an external call prefix
(
<EXT_CALL_PREFIX>
the secondary dial tone is played after the user dials 9 until any new digit
is entered. "9,3xxxxxx" means only when the digit 3 is hit would the
<SIP_2ND_TONE> stop playing.
PX This represents a pause of a defined time; X is the pause duration in
seconds. For instance, "P3" would represent pause duration of 3 seconds.
(0:9) This is a substitution rule where the first number is replaced by the
second. For example, "(4:723)xxxx" would replace "46789" with
"723-6789". If the substituted number (the first number) is empty, the
second number is added to the number dialed. For example, in
"(:1)xxxxxxxxxx", the digit 1 is appended to any 10-digit number dialed.
|
This separator is used to indicate the start of a new pattern. Can be used
to add multiple dialing rules to one pattern edit box.
A sample dial plan appears below.
Temporis IP150 Administration and Provisioning Guide
Select the default DTMF
transmission method. You may
need to adjust this if call
quality problems are triggering
unwanted DTMF tones or you
have problems sending DTMF
tones in general.
Enables the phone to
unregister the account(s) after
rebooting—before the
account(s) register again as
the phone starts up. If other
phones that share the same
account(s) unregister
unexpectedly in tandem with
the rebooting deskset, disable
this setting.
) before the comma. For instance, "9,xxxxxxx" means
Auto,
Event,
Inband,
SIP INFO
0: Disable
1: Enable
) after
<SIP_2ND_TONE>
ed 0.1 24/106
Auto
0