Line Menu - Alcatel Temporis IP150 Manual

If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an error
message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad and the Add
dot soft key to enter characters. Press  or  to advance to the next character.
3. Press  and enter the Subnet Mask. Use the dial pad and the Add dot soft key to
enter characters. Press  or  to advance to the next character.
4. Press  and enter the Gateway. Use the dial pad and the Add dot soft key to enter
characters. Press  or  to advance to the next character.
5. Press Save.
To set other settings (DNS and NTP):
1. From the Network setting menu, press  or  to highlight Others, then press
SELECT. The Others menu appears.
2. If DHCP is disabled or you don't wish to use the DHCP-assigned DNS server (or one
specified by your service provider), enter the IP address for the primary DNS server.
Use the dial pad and the Add dot soft key to enter characters. Press  or  to
advance to the next character.
3. Press  and enter the IP address for the secondary DNS server. The deskset uses this
server if the primary server does not respond.
4. Press  and enter the IP address for the NTP server. If the deskset does not use an
NTP server, you must manually enter the time and date settings.
5. Press Save.

Line Menu

Use the Line menu to configure line-specific settings for the phone.
On the Line menu, you can configure:
 Line status (Registered/Not registered)
 Line display name
 Line User ID
 Auth ID
 Password
 Server IP address
 Server Port number
 Proxy server IP address
 Proxy server port number
 Line registration
 Auto/manual answer page
To use the Line setting menu:
1. From the Admin Settings menu, press  to highlight Line, then press SELECT.
Temporis IP150 Administration and Provisioning Guide ed 0.1 17/106