Connection of main circuit terminals
Use a small minus screwdriver (with
blade width 2.5 to 3
mm).
It is introduced in the upper slot@ and
it's blade holds the spring open so that
the stripped power supply wire can be
introduced into the terminal
@.
Withdraw the screwdriver, the conductor
is clamped.
Connection of control circuit terminal
Insert a small minus screwdriver
(with blade width 2.5 to 3
mm)
into the
right hole
<9,
and insert the stripped
wire into
@
while pressing the
screwdriver in the direction of the
arrow. Remove the screwdriver when
the wire has been inserted.
(Note) Use a small flat-blade screwdriver (blade width 2.5 to
3mm).
-12-